喷塑设备保养的基本常识 |
添加时间:2020/7/1 13:50:21 浏览次数: |
喷塑设备保养的基本常识 Basic knowledge of spray equipment maintenance 每日的维护保养:除必须做每班/每日清理工作外,需要检查空气压缩机、空气干燥器工作是否正常,工件接地电阻是否正常(正常小于1兆欧)。 Daily maintenance: in addition to the cleaning work of each shift / day, it is necessary to check whether the air compressor and air dryer work normally and whether the grounding resistance of the workpiece is normal (less than 1 megohm). 每周的维护保养:供粉筒:清理所有的粉末,清扫干净,检查流化板时否受到污染.注意!在清理粉末时,不能用硬物刮擦流化板.否则将使流化板失去作用。 Weekly maintenance: powder supply barrel: clean all the powder, clean and check whether the fluidizing plate is polluted. Attention! When cleaning the powder, do not scrape the fluidizing plate with hard objects. Otherwise, the fluidizing plate will lose its function. 回收组件的保养:清除所有的粉末,清扫干净,检查传送泵内是否有积粉、粉块,如有,用压缩空气清理干净.滤芯上的粉末或更换新滤芯;检查流化板是否受到污染。 Maintenance of recycling components: remove all powder, clean, check whether there is powder accumulation and powder block in the transfer pump, if there is, clean it with compressed air. The powder on the filter element or replace with a new filter element; check whether the fluidizing plate is contaminated. |
上一页 工程质量的基础是工艺设计质量 |
下一页 静电喷塑优点 |
Copyright © 技术支持:遨游网络